 |
|
    |
|
    |
|
     |
| |
|
|
|
|
|
|
|
|
Current list of Tools Available Updated weekly * NO REFUNDS ON TOOLS * I do not rent tools or take them back after you use them! |
| 000 |
 |
  |
| T09 | M1 Carbine Rear Sight installation/removal Tool- This is an excellent tool we had custom made to install or remove flip or ajustable rear sights on the carbine. The follower was designed to move the sight from the lowest part of the sight as not to cause damage to your sight or receiver, Place in your vise as you see in pictures. Top picture is installing sight and bottom picture is removing sight- just flip tool around in your vise for fast and easy use as you can see in the pictures(follower will not grind against your valuble sight as some cheaper ones will).This simply locks into any vice and all you have to do is slide in the receiver and use a 9/16 wrench on either side. Are sight tool will NOT damage your receiver like cheaper models that clamp down. Beware of clamp down models that can scratch or even crack your receiver if over tighten. The only part you have to remove from your carbine to use this tool is the trigger house. NOTE: The manufacture has improved the design of this tool making it smaller and easier to use while adding addition quality at the same time. |
|
 |
| T01 | M1 Carbine Receiver Wrench- Excellent quality- We had these custom made to fit your receiver snug. It will help to prevent scratching and damage to your receiver.This one will fit over the bottom lug like the GI model for a secure fit! |
|
  |
| T02 | M1 Carbine Barrel Block |
|
 |
| T03 | M1 Carbine Piston Nut Wrench |
|
 |
| T04 | M1 Carbine Front Sight Removal Tool |
|
   |
| T13 | M1 Carbine front sight tool made by M1 Carbine Guru Bud Evers. This one is made the right way by WW2 vet Bud Evers and will not let you down. |
|
 |
| T11 | M1 Carbine Front Sight Tool, assembling (for installing front sight) |
|
 |
| T05 | M1 Carbine Bolt Tool |
|
 |
| T08 | M1 Carbine GI Bolt Tool |
|
 |
| T10 | M1 Carbine Trigger Spring Tool-Brass |
|
 |
| T07 | M1 Garand Bolt Tool |
|
| 000 |
|
 GEORGE LIAKOS, OWNER P.O. BOX 85 RIVERBANK, CA 95367 (209) 869-5576 |