1995 / Solid Freeform Fabrication Proceedings
PREV and NEXT link to numerically adjacent references for this YEAR.
CONTENTS links to the title list for this YEAR's references.
Author P.E. Reeves, R.C. Cobb University of Nottingham
Source Solid Freeform Fabrication Proceedings, 1995, pp 96-106
Abstract The use of StereoLithography (SL) can produce accurate prototype models with complex internal and external features. However, a major problem to commercial use is the poor surface finish caused mainly by "stair stepping" which is inherent in layer manufacturing. Models are often finished by hand but this is labour intensive, highly selective and causes inaccuracies in the model geometry. A three-year research project has been undertaken to address these issues and to investigate a range of surface coatings and mechanical finishing processes applied to SL models. This paper describes some initial findings using resin coatings applied to both cured and uncured SL parts. Initial findings suggest that excess resin retained after part stripping can result in a lower surface roughness than parts thoroughly cleaned prior to post curing. Through the addition of photocurable and epoxy based resins to parts in both the un-cured, green and cured states, surface roughness has been seen to be reduced by up to 50% on complex parts. (Auth abstract) [References: 7]
Solid Freeform Fabrication Proceedings can be obtained from: The Solid Freeform Fabrication Symposium
or contact:
The University of Texas at Austin
Laboratory for Freeform Fabrication / Texas Materials Institute
Mechanical Engineering Dept.
c/o The Solid Freeform Fabrication Symposium
MC C2200
Austin, TX 78712-1063 USA
512-471-3026; 512-471-7681 FX; Email: sffsymp@uts.cc.utexas.edu