|
1
|
This is Floyd Fronius performing a
rolling launch in the Goat1 at Horse Canyon in June of 2004.
I asked Floyd to "float it off" for the picture, and here's
the result. In August, 2005, Floyd flew from here on a cross
country flight of more than 60 miles, reaching altitudes
above 13,000 feet .
|
|
|
2
|
Here's the Goat1 where it landed after
the 100 kilometer cross country flight mentioned above. Floyd found a
perfect landing spot, a mile wide field of baked mud, on the
highway, with no fence. This is near Thermal, California, in
the Coachella Valley.
|
|
|
3
|
Bug2 is seen here launching from the
cliff at Torrey Pines Gliderport, San Diego, California, in
December, 2003. Floyd Fronius is the pilot, warmly dressed
and holding a cup of coffee in his left hand.
A smooth wind is
blowing at about 30 mph. into the 300 foot high cliff. Hang gliders can be seen high above, farther
down the ridge.
|
|
|
4
|
This could be an airchair at the start
of a tow, but it isn't. In a strong wind, on
a static line, Floyd Fronius is just floating in place as I take
this picture.This is the
Goat1 on a tethered flight at El Mirage Dry Lake, near
Palmdale, California, in July of 2004.
This image provides a good idea of the
maximium angle of attack of the aircraft, and provides a
good view of the hand deployed emergency parachute mounted
on the side of the nose below the pilot's seat.
|
|
|
5
|
Take a good look, you won't see many soaring biplanes. Here's the author myself in flight in
Bug4 over Horse Canyon, San Diego, California, in spring,
2004.
Note the reflection in my sun glasses (you can
see my left hand holding up the digital camera on the
horizon). A hang glider is visible just in front of my lower
right wing tip. Even when it is warm on the ground, an
insulated flight suit comes highly recommended for airchair
flying.
|
|
|
6
|
The boltaceous construction of the
Goat1 is what I call "garage technology". With no welding,
no machining, no molds, no jigs, no spray rig, it's mostly
tubes and cables put together with nuts and bolts.
That
bulge under a cover flap on the left strut junction is a
drogue chute which may be deployed in flight to add drag for
short field landings.The red and yellow handle is for the hand
deployed emergency parachute, which is rigged to bring down
the pilot and glider together, tail first. On the nose tube
you can read the aluminum alloy marking, "6061 T6", good
enough metal but nothing fancy.
|
|
|
7
|
A self portrait by Floyd Fronius in the Goat1,
this time over launch at Otay Mesa, San Diego, California,
in May of 2004. In open air flight, the view is complete and
when you are high you are really feeling it.
|
|
|
8
|
Goat3 gets walked up the hill for
another training flight, November 2006.
Novice training is not easy for the student pilot. There's a lot going on, with all
three controls needed from the very beginning, the need to steer while rolling, and
having to balance on a single wheel.
The basic training formula is: "nose
level, wings level, steer with your feet".
|
|
|
9
|
After the first high flight in Goat2, I
landed, stepped away, and took this picture.
The yellow
drogue cute, which can be seen collapsed on the ground, allowed me to come down steeply
over those bush tops in the background. The drogue also shortened my ground roll, so I
had only a short push back to the disassembly area. I use
a drogue chute for almost every landing in the Goat, in lieu
of airbrakes or spoilers.
|
|
|
10
|
Amid the flowers of spring, Bug4 sits
in the landing zone after a weekend soaring
flight.
This sesquiplane airchair has proven
to be practical and pleasingly compact, as well as stylish,
although it will never be a high speed flyer. April 2004.
|
|
|
11
|
Banked into a thermal and climbing, Goat3 is soaring over the California desert in summer, 2006.
The orange yarn on the little mast is the
yaw string, telling me I need a little more right rudder. The ball on a
line is the release handle, which I pulled to release the tow line at
the end of the aerotow, then wrapped around the nose tube to keep it
out of the way. The plastic tape on the nose tube is my pitch attitude
indicator, I keep it visually on the horizon, as shown, to maintain a
constant airspeed. Mounted higher up on the nose tube (but not visible in this photo) is my soaring (and only) instrument, a combination audio variometer and digital altimeter.
|

|
|
12
|
Shown here is the first test flight of
Goat3, just a low hop from a rolling launch down a
hill (Otay Mesa, San Diego, California, May 2006) This Goat
has a more sophisticated airfoil than Goat1, with a slightly
smaller wing area of the same span.
This wing was a little too small for
me in light conditions, so when I designed Goat4 I went back to the
original (larger) Goat1 & Goat2 wing area, allowing slower flight.
|

|
|
13
|
A prospective pilot sits in Goat4,
hoping for more wind. The wheel is chocked so the glider
will not roll backwards while windjamming, which means just
operating the controls on the ground for practice. This is
harder to do well than actual flying.
This was at Tehachapi, California,
September 1, 2007.
|

|
|
14
|
Flight instruction is underway in
Goat3 at a training hill, November 2006. The Goat nose is
down on the ground, as it is at the beginning and end of
most flights. This rolling launch will allow a brief
floating flight before a landing in the grassy field. Notice
the yellow hang glider which has just landed out in
front.
|

|
|
15
|
The Pig (Primary Instruction Glider)
is making it's first flight down the training hill on
October 18, 2007, in San Diego, California. This is a two
axis glider, controlled by elevator and rudder, with no
ailerons. It was launched by rolling down the slope on its two
BMX bicycle wheels (stylish, but no longer used).
|

|
|
16
|
Goat4 lifts off from the Horse Canyon,
(San Diego, California) launch slope on April 1, 2007. This
shows myself, the author, at the controls, performing a
reasonably stable rolling takeoff. With my original tail art
I am setting the spring fashion trends.
Photo by D.
Metzgar
|

|
|
17
|
The Pig has simpler controls and a lighter
wing loading than any of the Goats. Hopefully
this glider will allow infrequent or novice pilots to make more
satisfying flights and to make the usual mistakes with less
troublesome results than other designs.
Unlike the conventional three axis control system (yaw, pitch, and roll) this two axis control system (fast/slow, right/left) is
similar to that of hang gliders and paragliders, so they should readily
be able to make a transition to this machine without sailplane
training.
Here we see the Pig hooked up for truck towing in
September of 2008, Eric Lentz Gauthier at the controls.
|

|
| 18 |
For those who yearn to fly cross country
in an airchair, we're back to August 2005 at the landing site of
the100 kilometer Goat1 flight (see No.2 above). The tired but satisfied pilot, Floyd Fronius, is folding back an aileron to begin the disassembly for the drive home.
To get here, Floyd flew
over those mountains in the background (the Santa Rosas), and also over
the mountains on the other side of those (the Lagunas). |
 |